Threaded Refill Cap for No-Touch Soap Dispenser

Introduction:This design is originally by user @dpolz_208124 from printales.com. The original design is available under the Creative Commons Public Domain License, allowing me to distribute it further. At this point, however, a huge thanks to the designer and for making his project available.Print Settings:Filament: PLA, PETG or ABSLayer Height: 0.2mmWalls: 6 or moreTop/Bottom: 5 or moreInfill: 20%, gyoridSupport: YesSpeed: Normal speed (used 0.2mm Strength X1C Profile)Post-Printing Processes:After printing, remove the supports. For example, drill a hole using a stepped drill bit until the refill cap fits into the hole. Secure the cap inside the hole with a compatible adhesive. Optionally, use a seal approximately 19-21mm in diameter on the refill cap plug. Changelog:12.01.2024:After one good print, I ran into some issues, so I had to edit the print profile.added XY hole and contour compensation for a better fitting of the two partsincreased perimeters (using the Bambu Studio 0.2mm str