Thingiverse
Threaded spool holder 40/40
von satgod
11
Downloads
10
Likes
0
Makes
modified the base to fit 40/40 extrusions
This fits the Formbot, g-Create or any other 40/40 extrusion printer
recommend 70% PLUS infill
Up to the threads can be printed at any layer height but I recommend .2 layers for the threaded section to give good, easy to use of threads
Also at least for the threaded section I recommend printing INSIDE-OUT
This fits the Formbot, g-Create or any other 40/40 extrusion printer
recommend 70% PLUS infill
Up to the threads can be printed at any layer height but I recommend .2 layers for the threaded section to give good, easy to use of threads
Also at least for the threaded section I recommend printing INSIDE-OUT
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
