Threaded Teflon Tube Clamp

This Threaded Teflon Tube Clamp was designed by Michael Hackney from Sublime Layers (https://www.thingiverse.com/SublimeLayers/about) and is perfect for Delta printers

You will need a small (~5mmID) O-ring. Basically, insert the scroll wheel tube through the cap and then add the O-ring. Push the tube into the base plate so it seats all the way at the bottom. The O-ring will then be in the correct position. Screw on the cap - the compression of the O-ring keeps the tube in place without distortion.