Thingiverse
threaded through hole with slot
von fearthis4
5
Downloads
1
Likes
0
Makes
I made this for a heated drybox for the heater, but it should work with any standard 2 conductor electrical wire.
Threaded parts designed for a 20mm hole, but flange should work with up to a 26mm hole.
Has a slot in both parts to allow you to place over a wire without having to cut ends to get wire through.
Might recommend an oil or lubricant on back nut as it can be a little tough to thread dry, but once its tightened down it is not going anywhere.
Threaded parts designed for a 20mm hole, but flange should work with up to a 26mm hole.
Has a slot in both parts to allow you to place over a wire without having to cut ends to get wire through.
Might recommend an oil or lubricant on back nut as it can be a little tough to thread dry, but once its tightened down it is not going anywhere.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
