Three way splitter, no supports!

UPDATE 04.11.2023: Corrected a dimensioning error on the magnet holes. Apologies for the mistake! UPDATE 28.10.2023: Now prints without supports :) Also changed the magnet holes for hexagonal holes for easier printing and easier fitting of the magnets. Added a 4.1mm pocket for the bowden going to the toolhead for even better filament path alignment. --- A smooth three way splitter for using an AMS, rear spool holder and a drybox / secondary spool holder together on a Bambu. Smooth transitions to prevent filament snagging. I printed mine in 0.12mm layer height, which is recommended for this part. Mine is in ASA but other materials should be fine as well. Prints beautifully in 1.5hrs and only takes around 10g of filament. --- BOM: -printed part -5pcs 6x3mm magnets -4pcs PC4-M10 pneumatic fittings (like these, for example) Assembly: -insert magnets (use superglue if needed) -make sure a 4mm bowden tube fits the 4.1mm pocket on the bottom connection of the “Y”, test this before threading o