Thingiverse
Thrustmaster Locking Ring (Tested on a TS-XW)
di ST07AG11
4
Download
7
Likes
0
Makes
Thrustmaster Locking Ring tested on a TS-XW Only
Design Change: MrEverlost ... thanks to him
https://www.thingiverse.com/thing:4744923/files
Files EL-QR_1.2_+_0.3_hole.stl
Warning
The choice to take PC-CF is to avoid gambling over time !
The diameter was calculated based on the retraction of my “Nanovia-tech PC-CF” filament. I am attaching the IPT Inventor Pro files so you can modify it to match yours. Not all filaments react the same, especially if it is a PLA vs PC-CF print.
The rings must fit "very lightly" in force!!
Having no other steering wheel than the TS-XW, I cannot say that it works properly on other Thrustmaster models. But everything is possible by modifying my Inventor Pro IPT file.
Since I have been using this ring I have had no problem loosening the wheel and I no longer use screws. Tested for several hours in Drift on AC and Automobilista
Design Change: MrEverlost ... thanks to him
https://www.thingiverse.com/thing:4744923/files
Files EL-QR_1.2_+_0.3_hole.stl
Warning
The choice to take PC-CF is to avoid gambling over time !
The diameter was calculated based on the retraction of my “Nanovia-tech PC-CF” filament. I am attaching the IPT Inventor Pro files so you can modify it to match yours. Not all filaments react the same, especially if it is a PLA vs PC-CF print.
The rings must fit "very lightly" in force!!
Having no other steering wheel than the TS-XW, I cannot say that it works properly on other Thrustmaster models. But everything is possible by modifying my Inventor Pro IPT file.
Since I have been using this ring I have had no problem loosening the wheel and I no longer use screws. Tested for several hours in Drift on AC and Automobilista
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
