Thingiverse
Thrustmaster MFD Cougar Screen & Table Mount
by IdefixRC
157
Downloads
97
Likes
1
Makes
I wanted a solution for my Screen+Cougar MFD setup which I could easily remove and store without the need of additional clamps or screws aside what was already there from the Monstertech Joystick table mount.
This is how this table mount for 2 Thurstmaster MFD Cougar controllers + 11.6 inch LCD screen was born.
The screen/cougar assembly is one unit with a small USB hub on the back powering both MFD and the screen (yes I was surprised as well that one USB cable can power all that).
The complete assembly then slides into 2 rails mounted to the Monstertech 40x80 alu profile for a secure and, most importantly, wobble-free fit. one USB cable and one HDMI cable plug later and I'm ready for take-off in DCS and MSFS2020 :-)
To store, simply pull the screen upward, the mount will slide out of the rails and the only part left at the table is the montertech joystick mount with the small rail mounts on the side.
Suggest printing the parts at 50% infill and PETG for extra strength (also sands e
This is how this table mount for 2 Thurstmaster MFD Cougar controllers + 11.6 inch LCD screen was born.
The screen/cougar assembly is one unit with a small USB hub on the back powering both MFD and the screen (yes I was surprised as well that one USB cable can power all that).
The complete assembly then slides into 2 rails mounted to the Monstertech 40x80 alu profile for a secure and, most importantly, wobble-free fit. one USB cable and one HDMI cable plug later and I'm ready for take-off in DCS and MSFS2020 :-)
To store, simply pull the screen upward, the mount will slide out of the rails and the only part left at the table is the montertech joystick mount with the small rail mounts on the side.
Suggest printing the parts at 50% infill and PETG for extra strength (also sands e
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
