Thingiverse
Thrustmaster T300 buttons
door GRay_111111
41
Downloads
26
Likes
0
Makes
Swap your buttons for your favorite colors! Much easier to see when frantically trying to adjust settings or reset your car etc during racing!
I printed the slightly larger outer buttons, (the L2 R 2, SE etc) straight on my glass bed.
The smaller buttons (cross, circle etc) I printed on a raft.
All need supports as the inner area is raised up slightly (ie print with the bottom of the button on the bed (the face/cap pointing upwards).
I printed in PLA, super slow to get neat prints, at 0.16 layers 100% infill.
I printed the slightly larger outer buttons, (the L2 R 2, SE etc) straight on my glass bed.
The smaller buttons (cross, circle etc) I printed on a raft.
All need supports as the inner area is raised up slightly (ie print with the bottom of the button on the bed (the face/cap pointing upwards).
I printed in PLA, super slow to get neat prints, at 0.16 layers 100% infill.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
