Thingiverse
Thrustmaster T300 centre logo cap Sparco
door GRay_111111
43
Downloads
32
Likes
1
Makes
Center cap for T300 (May fit other wheels!)
Remove original center cap by carefully praising it out (it has four little hook legs that hold it in), stick this in place (I used bluetac, or double sided tape etc.)
Two colours achieved
by pausing print after main flat disc is printed and the logo has just started printing - swap filament, and resume.
Remove original center cap by carefully praising it out (it has four little hook legs that hold it in), stick this in place (I used bluetac, or double sided tape etc.)
Two colours achieved
by pausing print after main flat disc is printed and the logo has just started printing - swap filament, and resume.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
