Thrustmaster TLCM rumble motor mount

25mm rumble motor mount for Thrustmaster TLCM pedals.

I have use here two M4x5mm screws to tighten the motor. To mount it to pedal use washer and M4 nut on original pedal screw. It is not visible on picture.

As a rumble motor here I have used two 5V RF300 DC motors with external power, but it is possible to mount any rumble motor like 12V until diameter is around 25mm. You can also use VIN pin of arduino nano to power everything from one USB cable, but I have notice weaker strength.

I have printed it from PLA with 30% infill, but you need to experiment little with that, because higher infill will lower dumping of mount, but too high could be problematic to mount motor.