Thingiverse
Thumb/Toe Cuff
door bababbak
256
Downloads
194
Likes
2
Makes
**I recommend to use nade74’s remix using a metal spring, (https://www.thingiverse.com/thing:4785326) since the spring tends to deform overtime, causing the cuffs to not lock anymore.**
This is my take on Thumbcuffs, it's 100% 3D printable, and no additional hardware is required, even glue is optional! You need a **vise** to assemble it though. It holds itself together with dove joints. And the clip won't come of even if you didn't glue it and are pulling on it with pliers, and it even holds if the hinge snaps off due to the included groove. (I tested it) So it is **very Sturdy**.
You probably need to resize it to fit your toes.
Both sides are unlockable through only one key hole, and the keyhole has a little sinking to make picking harder, however even with a standart paperclip you can pick it while your tumbs are in there with relative ease. But i wanted to make sure that the key doesn't snap accidentaly.
Use a flexible material like Hard TPU for the ratchet spring, and a
This is my take on Thumbcuffs, it's 100% 3D printable, and no additional hardware is required, even glue is optional! You need a **vise** to assemble it though. It holds itself together with dove joints. And the clip won't come of even if you didn't glue it and are pulling on it with pliers, and it even holds if the hinge snaps off due to the included groove. (I tested it) So it is **very Sturdy**.
You probably need to resize it to fit your toes.
Both sides are unlockable through only one key hole, and the keyhole has a little sinking to make picking harder, however even with a standart paperclip you can pick it while your tumbs are in there with relative ease. But i wanted to make sure that the key doesn't snap accidentaly.
Use a flexible material like Hard TPU for the ratchet spring, and a
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
