Thingiverse
Thunderbird 3 Display Stand Corgi
por Thoma5
4
Descargas
20
Likes
0
Makes
Corgi Thunderbird 3 Display Stand
Printed at 0.2mm w. 0.4mm Nozzle - PETG - PLA should work with this however.
15% Infill (honeycomb is my preference because hexagons are the bestagons).
Walls >2. Top & Bottom layers set to >3.
It can be printed with no supports however if cooling is not adequate for the desired filament type use the below advice.
It is recommended to add painted supports in the desired area (see picture). My preference is Tree supports due to the geometry of this part.
Happy Printing
Printed at 0.2mm w. 0.4mm Nozzle - PETG - PLA should work with this however.
15% Infill (honeycomb is my preference because hexagons are the bestagons).
Walls >2. Top & Bottom layers set to >3.
It can be printed with no supports however if cooling is not adequate for the desired filament type use the below advice.
It is recommended to add painted supports in the desired area (see picture). My preference is Tree supports due to the geometry of this part.
Happy Printing
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
