Thundershot SuperSnub Kit

Designed this as a kit to replace the over-long barrel, and tiny grip. Now your pinky isn't left dangling in the wind.

There are also 3 versions of the muzzle, Classic, Tactical, and Stubby. All three work the exact same, so you can just pick whichever one you like most.

Also included is a spring spacer. This is placed behind the spring, and slips over the top of the plunger rod. No need to remove the plunger head pin. This not only adds a bit of extra precompression to the spring (more power), but also reduces the amount the plunger tube can slide, which gives a better seal from the plunger tube to the cylinder.

And now, A Hammer mod is also available. This brings the hammer back by quite a bit, making it easier to prime one-handed. It's still a bit more of a reach than a Hammershot, but it's the best I could do without requiring you to cut up the shell.

Printing:

PLA

1-3mm Layer Height

10-15% Infill

2+ perimeters

Everything should simply integrate directly