Tib Bar

#DIY Tib Bar

This is my diy tib bar I use for doing tib raises. It's not the cheapest DIY solution, I had a bunch of pipe nipples leftover from another project and decided to use them to make a tib bar that utilizes 2" plates.

## Materials Required

- [Qty: 4] [1" Steel Pipe Nipple, 6" Long](https://www.mcmaster.com/44615K486/)
- [Qty: 1] [1" Steel Pipe Nipple, 1 1/2" Long](https://www.mcmaster.com/44615K416/)
- [Qty: 1] [1" Steel Pipe Nipple, 2" Long](https://www.mcmaster.com/44615K436/)
- [Qty: 1] [1" Steel Pipe Nipple, 8" Long](https://www.mcmaster.com/44615K526/)
- [Qty: 3] [1" Steel Pipe Tee](https://www.mcmaster.com/44605K156/)
- [Qty: 4] [1" Steel Pipe Cap](https://www.mcmaster.com/44605K654/)
- [Qty: 1] [Wire-Lock Clevis Pin, 5/16" Diameter, 2 1/8" usable length](https://www.mcmaster.com/98416A014/)
- [Qty: 1] [1" Foam Pipe Insulation, ~1ft total length needed](https://www.mcmaster.com/4530K166/)
- [Qty: 1] [Roll of electrical tape](https://www.mcmaster.com/7645