Thingiverse
Tick Remover
por Iron_Scorpion
2.5k
Descargas
1.6k
Likes
10
Makes
Tick remover.
Ticks are getting worse and worse in my area. It seems like every time I have gone hiking someone in the group has had a tick on them.
- As small as a dog tag so it can be on their collar, a keychain, or in your wallet. Small enough to always carry
- Weighs nearly nothing, ~1g of PLA
- Fast print.
- Smaller than store bought, so it fits into tighter areas where ticks like to hide.
- Has a keyring hole.
- Ender 3 can print around 35 at one time. Hand them out to other hikers.
How to use:
For example if you have a tick on your leg, just lay the remover flat on your leg with the tick in the large center opening. Then slide the remover to the small opening so the tick is snared around the neck. Then lift and the tick comes out whole.
Since the tick is pinched at the neck they cannot regurgitate to cause complications.
I have been using these for years and they work great. I have great success with them removing the entire tick.
Ticks are getting worse and worse in my area. It seems like every time I have gone hiking someone in the group has had a tick on them.
- As small as a dog tag so it can be on their collar, a keychain, or in your wallet. Small enough to always carry
- Weighs nearly nothing, ~1g of PLA
- Fast print.
- Smaller than store bought, so it fits into tighter areas where ticks like to hide.
- Has a keyring hole.
- Ender 3 can print around 35 at one time. Hand them out to other hikers.
How to use:
For example if you have a tick on your leg, just lay the remover flat on your leg with the tick in the large center opening. Then slide the remover to the small opening so the tick is snared around the neck. Then lift and the tick comes out whole.
Since the tick is pinched at the neck they cannot regurgitate to cause complications.
I have been using these for years and they work great. I have great success with them removing the entire tick.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
