Slicer Discord
Tick Tool Tweezers Picker Fast – 3D-printbaar model van MakerOnline MakerOnline
Tools

Tick Tool Tweezers Picker Fast

door marcel.aux · Tools
233 Downloads
64 Likes
0 Makes
Model downloaden
Hello everyone, this time it has become a pair of tick tweezers “due to the season”. Due to the warm and humid weather in Germany, the ticks are very bad at the moment.   It prints quick and uses little material!   To properly remove a tick, follow these steps (by ChatGPT): Pull Upward with Steady, Even Pressure: Avoid twisting or jerking the tick, which can cause the mouth-parts to break off and remain in the skin. Clean the Bite Area: After removing the tick, clean the bite area and your hands with rubbing alcohol, an iodine scrub, or soap and water. Dispose of the Tick Properly: Place the tick in alcohol, a sealed bag/container, or flush it down the toilet. Do not crush it with your fingers. Monitor for Symptoms: Watch the bite area for signs of rash or infection, and seek medical advice if you experience fever, chills, or other symptoms. It's important to remove the tick as soon as possible to reduce the risk of disease transmission.   Have fun with it and as always, be cool to each other!   Cheers, Marcel <3
Categorie
Tools
Bron
MakerOnline
Gepubliceerd
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie