Ticwatch S & E Charging Stand

A small charging stand for the Ticwatch S & E models. These only come with a magnetic usb cable. This stand integrates the connector with the stand. The USB cable is threaded through front to back and the cable is then set into the channel to run the cable cleanly to the bottom. I used a small amount of hot glue to fasten the magnetic charging connector to the stand.

I printed with ABS so if you are printing with another material, the tolerances may be off some.

I have added a "v3" which has additional notches that should accommodate the Ticwatch E band holders. Once I get some feedback that it works, then I will just leave the v3 as the only version.