Tie MK II

Tie MKII based off of the Tie and concept art from the Mandalorian (landing capable)
I have not gotten a way to hinge the wings but likely they would flop over.
This has been remixed from here https://www.thingiverse.com/thing:3035348

To print you need 2 of each wing piece (for left and right wing obviously)
1 of each landing gear and yes they do matter where they go.
1 fusalage
2 caps

To assemble:
Glue the 8 wing halves together:
Creates 2 flight wings
Creates 2 Landed position wings.
use 3MM x 2.5MM (0.125in x 0.95) (ish) magnets
Expect wobbly results due to magnet strength (i ended up gluing mine)

Print is untested in this stage (mine had more magnet holes)