Tight stringtest with Supportelement
door printaddict3d
0
Downloads
1
Likes
0
Makes
I needed a fast stringtest with a supportelement that was tighter than the ones i found here.
With this stringtest you can check if retractions between near objects and supports are working.
With low speed (25mm/s) the test takes under 20 Minutes.
With this stringtest you can check if retractions between near objects and supports are working.
With low speed (25mm/s) the test takes under 20 Minutes.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!