Thingiverse
Tilt Knob for ETC Source Four
von JTPickering
3
Downloads
4
Likes
0
Makes
Replacement tilt knob for ETC Source Four theatrical lights. Designed as close to the original as possible. The hole is sized to accept a 5/16"-18 heat-set insert, or if you're replacing a broken one, you can cut the insert out of it and re-use it. You may have to scale it up a few percent to account for shrinkage depending on your filament/settings.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
