Tinker-Friendly Parsons Table Enclosure

This is a remix of the Tinker-Friendly LACK Enclosure designed by zuspiel. It is designed for Mainstays Parsons End table. because the table itself is smaller in the x and y, my Anet A8 will have to be installed at a 45-degree angle to the table. Because the legs also incredibly short, I had to lengthen the extention.

Once printed, the dimensions appear to be *almost* right, but it requires a tiny bit of pressure to seat, and there was a noticeable seam. I did not personally mind it, but if the diameter of the knob on the top half were reduced by a millimeter or two, it would make it pretty seamless.

The finished setup utilizes yoga mat material, and I have used some brackets (http://www.thingiverse.com/thing:2001275) to hold it down and help reinforce the frame.