Thingiverse
Tiny Cork Board Shelves
by frostyfriday
119
Downloads
113
Likes
0
Makes
I had had a couple of small things leaning against the wall at the back of my desk and decided it would be nicer to put them on a shelf on the cork board instead.
They have a lip so things don't slip off.
Hence the "Tiny Cork Board Shelves". The first one is 65mm wide by 20mm deep.
They are held into the cork board using a map pin. Mine are have about a 5mm plastic ball head and are about 15mm long overall.
This is the first of a few I will design. The next one will be about as long as a business card.
Send a pic of what you put on your "Tiny Cork Board Shelf". I'd love to see what you are suing them for.
I use a Tinkerine DittoPro to print mine in PLA using 2 shells, 0.3mm layer height, 18% infill, no support and it took about 38mins.
They have a lip so things don't slip off.
Hence the "Tiny Cork Board Shelves". The first one is 65mm wide by 20mm deep.
They are held into the cork board using a map pin. Mine are have about a 5mm plastic ball head and are about 15mm long overall.
This is the first of a few I will design. The next one will be about as long as a business card.
Send a pic of what you put on your "Tiny Cork Board Shelf". I'd love to see what you are suing them for.
I use a Tinkerine DittoPro to print mine in PLA using 2 shells, 0.3mm layer height, 18% infill, no support and it took about 38mins.
frostyfriday also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
