Slicer Discord
Tiny Keychain Micro SD Card Holder (for 2 cards) – 3D-printbaar model van MakerWorld MakerWorld
Office

Tiny Keychain Micro SD Card Holder (for 2 cards)

21 Downloads
8 Likes
9 Makes
Model downloaden
Hello,this is a holder for 2 micro SD cards that can be attached to a keychain.The holder snaps into place easily and is then securely closed. The tab on the side has a snall notch to make it easier to open the holder again.I tried to make it as small as possible to reduce the likelihood of it getting tangled on a keyring or in your pockets.The hole for the keychain has a diameter of 4 mm.I recommend bending the joint manually after printing, so that it closes the holder properly later.One important last thing:I have a good gut feeling about the holder, but I have not yet been able to test it for a long time. So please don't use it to transport sd cards that you can't afford to lose!!! ThanksPlease leave a comment or shoot me a message if you like the holder or have any ideas how it could or should be improved. Thank you! :-)If it does not work for you please leave a comment or shoot me a message instead of just posting a 1 star review, I'm sure there is no problem that can
Categorie
Office
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Min. bedgrootte
50 mm (Klein)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie