Tiny Quad Pod 2s - 65x

File missing for revision.



Tiny Quad Pod 2s, the perfect pocket protector for your 2s Brushless Whoop

1s brushless whoops (UR65 etc) will also fit this 2s case, but you can also fin the 1s specific version here:
https://www.thingiverse.com/thing:3114439


Version for 6mm brushed frames, the Tiny Whoop Coop can be found here:
https://www.thingiverse.com/thing:3115364

Print Settings
1) Use 0.5mm line width for the best walls. This is fine even if you are using a 0.4mm nozzle, just change the "line width" or "extrusion width" setting in your slicer.
2) The lid snap fits onto the sleeve, so tight tolerances are required. If your extrusion is not calibrated precisely you may find that the lid doesn't fit. In this case scale the lid very slightly in your slicer, but not too much or the snap fit won't work. I would try with a minuscule 0.2% increase if needed.

I enjoy printing these with Cura's Fuzzy Skin setting to get the case a nice texture. If you do this, i recomme