Thingiverse

Tiny trebuchet

by tthayer1

9 Downloads

4 Likes

0 Makes

This is a little trebuchet that I made so I could print it. My intention with the open end is to stack quarters or nickels in there and rubber band them in place. As for the throwing end, all you should need is some thread and a small patch of cloth. Tie or sew the thread onto each side of the cloth. Then tie a loop in one of the pieces of thread this will loop over the uppermost part of the arm. Then tie the other end to the trebuchet's arm in the small hole. I designed this so I could print it on a 100x100x100 printer, but this should scale find.

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format