Tiny TV Remote Control Case (Tiny Circuits TinyTV Kit)

I recently purchased a Tiny TV kit from Tiny Circuits and though the kit comes with a 3D printed TV shell, I couldn't find any designs for the tv remote control board. I designed a few versions for anyone wanting to have a shell case on their Tiny TV Remote.

This design is specifically designed for the Tiny Circuits Tiny TV Kit.

I'm new to 3D designing so I hope this design prints good for you. The design tolerances are pretty tight, and you may need to trim the corners of the rim where the two sides slide together. I've printed and tested all the TV Remote designs and they all work, but each needed a small pair of pliers to lightly squeeze the shell together. Just be sure you've cleaned up any residue and scraps that may interfere with the lip from sliding into the other half as well as the holes for the buttons.

You will also find a bonus file of the remote board reference I created to help designing these shell cases.

The "classic" remote shell prints best face up, wh