Thingiverse
Tiny Whoop Brushless
von BdejaN
797
Downloads
642
Likes
6
Makes
Brushless Tiny Whoop
Duct for each motor printed as separate part, so if you break one you don't have to print entire frame.
Print each part twice and put everything together like this:
https://www.youtube.com/watch?v=ICViKRukXuo
Designed for following parts:
Motors: Racerstar 1103 8000kv/10000kv
Propeller: DYS 2030
Flight controller: Pico BLX (20mm x 20mm mounting holes)
ESC: 4in1 racerstar 6A (20mm x 20mm)
Battery: 2s
Finished product should look like this:
https://www.youtube.com/watch?v=j3msxzyWhr4
3d printed:
https://www.youtube.com/watch?v=rPKuajP53lA
-------------------------------------------------------------
Added 3-inch version (77.5mm inner diameter)
Haven’t printed it yet so I don’t know if it is sturdy enough.
- Duct wall is 0.8mm tick – two layers if using 0.4mm nozzle
- Angled struts
- Slots for motor wires. Braking duct doesn’t require disordering
-------------------------------------------------------------
Added 40mm version
Duct for each motor printed as separate part, so if you break one you don't have to print entire frame.
Print each part twice and put everything together like this:
https://www.youtube.com/watch?v=ICViKRukXuo
Designed for following parts:
Motors: Racerstar 1103 8000kv/10000kv
Propeller: DYS 2030
Flight controller: Pico BLX (20mm x 20mm mounting holes)
ESC: 4in1 racerstar 6A (20mm x 20mm)
Battery: 2s
Finished product should look like this:
https://www.youtube.com/watch?v=j3msxzyWhr4
3d printed:
https://www.youtube.com/watch?v=rPKuajP53lA
-------------------------------------------------------------
Added 3-inch version (77.5mm inner diameter)
Haven’t printed it yet so I don’t know if it is sturdy enough.
- Duct wall is 0.8mm tick – two layers if using 0.4mm nozzle
- Angled struts
- Slots for motor wires. Braking duct doesn’t require disordering
-------------------------------------------------------------
Added 40mm version
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!