Tiny Whoop E010 case with tray

Remix of the excellent case by ByteSlinger.

I added a middle tray for more batteries, resized the lid to suit my lower TW (whip antenna)

Tray will be a very tight fit, and most likely need a little sanding on the outer edges before it will fit in position. You can sand it to get as tight or loose fit as needed.
(I just used some 400grit paper and spent ten minutes sanding, fitting etc.)
I had the 5 pack charger that comes with the 45c E010 batteries from Banggood (very good batteries! ) I cut down the wires, resoldered them for less mess, then taped to the inside of the lid as a charging tray. Works well.

Printed in PLA (Excelvan green).
0.2 layes, takes about 7 hours for the base (!) , 6 for the lid and about 2 or so for the tray.
Quite a long print but the original design of this case is a really nice and chunky., feels good when done.

Picture of the black case, - the black lid is one I redesigned to have a lower height - it cant fit the charger in the lid space. But