Thingiverse

Tiny Whoop Launching Pad

by kwongkan

289 Downloads

212 Likes

3 Makes

##***WHOOP!***##
Racing style launching pad for Tiny Whoop, Blade Inductrix or similar brushed quadcopters. Launching your quad in a canted forward position allows starting at a higher speed, eliminating the need of climbing before gaining forward speed.

**Update:**
- **31 Oct 2017**
- Modified ball/socket geometry for a stiffer joint.
- Tweaked motor dimple positions to for better fitting.

**Features:**
- Ball joint design allows pivoting up to approx. 20 degrees in any direction.
- Thin arms prevents unintentional lifting your quad by ground effect, especially from idle speed / air mode.
- Dimple shaped recesses provide just enough retention without "sinking" too deep into the launching pad.

**Notes:**
- Launching in extreme angle can be problematic if your quad is in **Angle / Horizon / auto-leveling modes**, launching in **Acro / Rate Mode** is recommended, or just do the whole race in Acro, it's challenging and FUN!
- **Test ability to arm before flig

Blade Inductrix drone fpv fpv racer quad Quadcopter racing drone Tinywhoop tiny whoop whoop Blade Inductrix drone fpv fpv racer quad Quadcopter racing drone Tinywhoop tiny whoop whoop Blade Inductrix drone fpv fpv racer quad Quadcopter racing drone Tinywhoop tiny whoop whoop

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format