Thingiverse
TinyEYE Quadcopter Frame
von robbjosh
37
Downloads
30
Likes
0
Makes
*UPDATE_V1*
19 Jan 2019
This is a frame I designed which was inspired by KababFPV's Toothpick. It is only 2mm thick because I will use this design to cut the frame out of carbon fiber. I have flown this, however it's still a work in progress, so any comments are appreciated.
Rubber bands are used to hole the LiPo in place as seen in the pictures. I haven't made a camera mount yet for this frame. I am still in the process of that, not sure if I want an ordinary mount or a pod. Weight with battery is 34g.
*PARTS*
• BetaFPV AIO F4 1S FC
• Happymodel 0802 16000kv Motors
• AIO Cam + VTX 25mw
• 56mm KingKong Bi-Blade Props
• Happymodel 1S 450mAh 30C HV Lipos
19 Jan 2019
This is a frame I designed which was inspired by KababFPV's Toothpick. It is only 2mm thick because I will use this design to cut the frame out of carbon fiber. I have flown this, however it's still a work in progress, so any comments are appreciated.
Rubber bands are used to hole the LiPo in place as seen in the pictures. I haven't made a camera mount yet for this frame. I am still in the process of that, not sure if I want an ordinary mount or a pod. Weight with battery is 34g.
*PARTS*
• BetaFPV AIO F4 1S FC
• Happymodel 0802 16000kv Motors
• AIO Cam + VTX 25mw
• 56mm KingKong Bi-Blade Props
• Happymodel 1S 450mAh 30C HV Lipos
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
