Tinyhawk 2 Freestyle Runcam 3 Split Lite Mount! (TPU)

NOTE BEFORE PRINTING!
-RUNCAM SPLIT 3 LITE ONLY (no mounting options)
-Requires Longer Nylon Standoffs! (Suggested link at bottom)
-TPU! This is a camera mount, Non TPU may cause Jello or Vibrations
- SWAP THE PINS ON THE RUNCAMSPLIT - the runcam splits plug fits, but the cables are out of order from what the board wants, check the pins on the runcam 3 and you will find what order they should be in.

Supports helped a lot on the back curve

Mount works perfectly, Fits snug perfectly into the Bottom Frame, then squishes by the top using M2(20mm) Double-Pass on the 4 main structures. Then use a M2(6mm+6mm) Single Head to extend off the rear Standoff for the flight controller, this will allow you to mount the main board. BE SURE TO HAVE ACCESS TO THE MEMORY CARD. (also, you do not NEED to zip-tie the camera in, but... Just in case...)

besides that, i kinda just made it work \_(o.0)_/

Enjoy!

Designed by TENTANKLES
Flown by SQUOWL
CHECK OUT OUR YOURTUBE FOR FLIGHT F