Thingiverse
TinyHawk Freestyle 2 Top & Bottom Frame
por Arpeman
87
Descargas
55
Likes
0
Makes
TinyHawk Freestyle II Bottom Plate Frame
3 versions.
Close to original frame.
2mm arms supported frame.
2mm thicker than first one with all screws are recessed.
"NEW added Top plate .STL
If your printer can print dimensions correctly this model is ready to use directly out from printer.
If not you might need drill and file to adjust it a little bit.
I recommend use little hotter hotend than normal so it becomes little bit stronger
and anything else you know that can make it stronger is not bad idea to use.
My test on this frame has been success.
Few crashes and sliding and it's still going to sky with no problem.
What I had to replace was some zip ties so far.
(tested version 2.mm supported)
3 versions.
Close to original frame.
2mm arms supported frame.
2mm thicker than first one with all screws are recessed.
"NEW added Top plate .STL
If your printer can print dimensions correctly this model is ready to use directly out from printer.
If not you might need drill and file to adjust it a little bit.
I recommend use little hotter hotend than normal so it becomes little bit stronger
and anything else you know that can make it stronger is not bad idea to use.
My test on this frame has been success.
Few crashes and sliding and it's still going to sky with no problem.
What I had to replace was some zip ties so far.
(tested version 2.mm supported)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
