TinyTrainer Camera Mount 10-50 degrees

This camera mount is based on the original, with the size and camera position being the same, but the difference here is that I created this in my own editor (DesignSpark Mechanical) so can much more easily modify it than hacking at the original camera mount STL.

I've set the camera tilt range from 10 degrees to 50 degrees, to fit a lens with a max outer diameter of 13mm (like the Foxeer DigiSight in the photos).

I created a 2nd version where the camera is pushed forwards by 10mm to reduce props in view and push the battery forwards to better help with getting the center of mass being more centered in the craft.

Plus two other variants with the front 'wedge' dropped down by 7.7mm for my own craft to help keep the end of the battery from being bumped/smashed during landings/crashes.

____

Print in TPU, 0.2mm layer height, 3 perimeters, no support - I included 3 support struts into the design which have an 0.2mm gap vertically so they should snap off easily afterwards, as s