Thingiverse
TinyWing Layout
von SnappyDIY
24
Downloads
26
Likes
0
Makes
## In Progress
Wing Layout for a TinyWing like Inductrix Air Awitch. Just transfer it to a foam board.
Compatible with any TinyWhoop like http://bit.ly/EachineE010TinyWhoop
Foam is 3mm - need lightweight!
Use Foam Glue like Uhu POR to fix Whoop in Foam
Adjust Angle of back Props ~35°
Wing Layout for a TinyWing like Inductrix Air Awitch. Just transfer it to a foam board.
Compatible with any TinyWhoop like http://bit.ly/EachineE010TinyWhoop
Foam is 3mm - need lightweight!
Use Foam Glue like Uhu POR to fix Whoop in Foam
Adjust Angle of back Props ~35°
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
