Thingiverse
Tip - Folding Camp Table
door wsmac7
7
Downloads
3
Likes
0
Makes
Tip inserted into horizontal bar, designed to slip into bracket mounted underneath slatted, folding, table top.
.
PLA white and blue
.
12/27/2015
Uploaded final files and images of a successful print!
They fit just fine... a bit snugger than the originals, which is a good thing!
I could have not moved the block inwards so much to create that slot in the larger end, but even with the larger slot, the end holds well to the tubing it goes on.
Definitely worked better to go back and recreate the item by starting off with a full-sized cylinder, then 'difference'ing what I needed to remove.
What I did originally was to create an upper cylinder, lower cylinder, the 'difference' cylinders(subtracted elements in OpenSCAD)... which caused this to print as units put together rather than one piece.
The original prints were weak because of this.
.
PLA white and blue
.
12/27/2015
Uploaded final files and images of a successful print!
They fit just fine... a bit snugger than the originals, which is a good thing!
I could have not moved the block inwards so much to create that slot in the larger end, but even with the larger slot, the end holds well to the tubing it goes on.
Definitely worked better to go back and recreate the item by starting off with a full-sized cylinder, then 'difference'ing what I needed to remove.
What I did originally was to create an upper cylinder, lower cylinder, the 'difference' cylinders(subtracted elements in OpenSCAD)... which caused this to print as units put together rather than one piece.
The original prints were weak because of this.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!