Thingiverse
Tippmann X7 Phenom Foregrip
von Jexoteric
27
Downloads
37
Likes
0
Makes
X7 Phenom angled foregrip designed for use with the X7 Flatline barrel (it is too long for the stock barrel shroud + a few other differences).
I printed this with the face that aligns against the magazine as the base (as shown in the picture), and used supports on the base plate only with good results. If you are going to use supports all over, then put it on its side.
Requires 1x Screw and 1x nut, below are the McMaster numbers I designed it around, but you may find cheaper options at your local store if they sell them in small quantities.
Screw: McMaster 91255A273 (10-32 x 1" Black finish BHCS)
Nut: McMaster 92362A160 (10-32 Black finish thin nut)
I printed this with the face that aligns against the magazine as the base (as shown in the picture), and used supports on the base plate only with good results. If you are going to use supports all over, then put it on its side.
Requires 1x Screw and 1x nut, below are the McMaster numbers I designed it around, but you may find cheaper options at your local store if they sell them in small quantities.
Screw: McMaster 91255A273 (10-32 x 1" Black finish BHCS)
Nut: McMaster 92362A160 (10-32 Black finish thin nut)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
