Thingiverse
TLR7A Extended Switches
von TommyFlyHunter
4
Downloads
2
Likes
1
Makes
Printed at 0.1 mm layer height, 100% infill, at least 3 wall loops recommended. No supports needed. Brim recommended.
Compatible with Streamlight TLR-7, TLR-8, TLR-9, and TLR-10 series of lights (except the original TLR-7 with the sliding switches).
No interference with trigger guard. No effect on holster compatibility. Can be activated by non-dominant hand's thumb or dominant hand's index-finger.
Pads can be stippled for texture.
Compatible with Streamlight TLR-7, TLR-8, TLR-9, and TLR-10 series of lights (except the original TLR-7 with the sliding switches).
No interference with trigger guard. No effect on holster compatibility. Can be activated by non-dominant hand's thumb or dominant hand's index-finger.
Pads can be stippled for texture.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
