Thingiverse
Toaster Handle
door PlasticyBits
1
Downloads
0
Likes
0
Makes
The very first thing I designed on OnShape and printed on the free Anet A8.
Simple handle for the Sunbeam toaster; the part you push down to start to start toasting. Much better then pushing down on bare metal.
Print as per the picture; 1.2mm shell and 30% infill.
No brim or raft needed.
Glue on using Urethane (i.e. Gorilla Glue) or Epoxy
July 2022
The Sunbeam toaster is long gone and the new toaster handle is already coming loose. So I figured I'd draw up a replacement for when it breaks or ends up lost.
This one is a round design. There are two versions; one with the detail groove like the original and a plain surfaced version.
Simple handle for the Sunbeam toaster; the part you push down to start to start toasting. Much better then pushing down on bare metal.
Print as per the picture; 1.2mm shell and 30% infill.
No brim or raft needed.
Glue on using Urethane (i.e. Gorilla Glue) or Epoxy
July 2022
The Sunbeam toaster is long gone and the new toaster handle is already coming loose. So I figured I'd draw up a replacement for when it breaks or ends up lost.
This one is a round design. There are two versions; one with the detail groove like the original and a plain surfaced version.
PlasticyBits publiceert ook op
32 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
