Tobii Eye 5 Stand

The STL was exported from blender as meters as the flashforge software uses blender's meters measurement (mm comes out hilariously tiny). Included is the source .blend.

The holes in the mounting point are more as markers for where the magnets on the eyetracker are located. Drilling them to your needed size with a little counter sink will allow you to use screws instead of the adhesive pad.

The pictures are of V1.0 which had quite a bit of wobble. To compensate I spread the stands out a bit to stop the wobble.

Update 2-27-2022: Re-meshed stand for better connections to top and bottom, should yield higher strength.