Tobii Eyetracking 4c Clip

Clip for the Tobii 4c Eyetracker.

Two clips need to be printed. One of the printed clips will need to be mirrored in the slicer because they are meant to be handed.

I printed mine at 1.2mm layer height with a 0.6mm nozzle. I use a 1800R curved monitor and the clip is set to 15 degrees from the underside of the monitor.
The clip is adhered using 3M VHB (6mm wide glazing tape).

Installation:
(1) Install double sided tape (make sure you clean the surfaces before applying tape)
(2) Slide the clips onto Tobii 4c.
(3) Run the Tobii display setup.
(4) Remove film from double sided tape.
(5) Align with the marks on the monitor and press the eyetracker in place.