Tofu Press

I printed this in PLA. It requires two springs to fit over the posts. I picked these up locally. It may be necessary to heat the arms of the lid and bend them inwards slightly. Some printers tend to cause them to spread outwards, making them less likely to catch on the body and hold the press in place.

Update: I thought I should be a little more specific regarding the springs I used. While I picked them up at a local fastener store, they are made by Century Spring Corp (www.centuryspring.com). They are the C-756 utility compression spring (23/32 x 3-1/2 x 0.41 inches). Hope this helps.