Tonuino Case

I created my own case for the Tonuino Project: https://voss.earth/tonuino
Printed using PLA+ in three different colors (silver, white and transparent).

Parts I’ve used:

• switch: https://www.ebay.de/itm/Mini-Kippschalter-Wippschalter-Switch-2-Pin-250V-3A-125V-6A-Ein-Aus/184189464527?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

• Arduino Nano
• DFPlayer mini
• 3W 4Ohms Speaker (52mm)
• RFID module MFRC522
• 13,56 MHZ RFID Coins (20mm)
• P4056 Lithium Li-ion charging and protection module
• 18650 Li-ion cell
• Mini USB breakout board (battery charging and SD-card data transfer)
• 5V StepUp
• two diodes
• three 6x6x6mm tactile buttons
• two 1k resistors (for RX/TX on the mp3 player)
• Self-tapping screws (M2x5mm, M2x8mm & M3x5mm)
• 1206 led green (removed the red LED on the RFID module and placed the green one on the backside using the led pads from the red LED)


You can remove the 18650 cell, the step-up, the diodes and the charging module from th