Tool Caddy for Wanhao Duplicator i3

** [I'm no longer posting any new models of updates to Thingiverse. Please check out my page at https://www.printables.com/social/48520-fuchsr/models]**

UPDATE 5/21/2020: Added glue-on hook for scraper or similar tools.

I recently printed [OneTrueMyth's Tool Caddy](https://www.thingiverse.com/thing:3783170) for my Prusa Mk3S and liked it a lot. Then I glanced over at my trusted Wanhao i3 and thought "mmh, this may actually look pretty good on the i3 too."

So an hour later, the tool caddy was outfit with the connector component of [dragg's allen & scraper support](https://www.thingiverse.com/thing:1627237).

The connector fits into the gap between Z axes towers. I found it to be quite a tight fit and requires a bit of force to get in but YMMV.

On my Mk3S it prints fine without supports, not sure the Di3 will do as well with the bridging for the large tray. Look at [OneTrueMyth's original design](https://www.thingiverse.com/thing:3783170) for a tray liner to cover the bri