Thingiverse
Tool Changer Head 2020 Extrusion
door mrmanjf
28
Downloads
26
Likes
0
Makes
This is a modular tool changer head and carriage for 2020 extrusions, specifically for the E3D V6. I have changed the design I will be using on my personal machine ("OneCube" tool changer project on my page), but decided to upload my original design also.
These parts are UNTESTED, and will not be updated unless I find a need for them, or if someone requests a specific feature, update, or issue.
The 6 cutouts are meant for 8x3mm magnets to be glued in. Depending on the strength of the magnets you most likely will not need to fill all the cutouts. Experiment and see what works best for you and your machine.
The toolhead has a built in part cooling fan duct on the side. This is not the ideal setup but i wanted to have it built in with as little space wasted as possible, so it should work well enough. It uses two 25mm fans in order to get a larger flow in a smaller space. The heat sync fan is the standard V6 fan and standard clip on shroud which slide through the side cutout afte
These parts are UNTESTED, and will not be updated unless I find a need for them, or if someone requests a specific feature, update, or issue.
The 6 cutouts are meant for 8x3mm magnets to be glued in. Depending on the strength of the magnets you most likely will not need to fill all the cutouts. Experiment and see what works best for you and your machine.
The toolhead has a built in part cooling fan duct on the side. This is not the ideal setup but i wanted to have it built in with as little space wasted as possible, so it should work well enough. It uses two 25mm fans in order to get a larger flow in a smaller space. The heat sync fan is the standard V6 fan and standard clip on shroud which slide through the side cutout afte
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
