Tooth Spider
por mibus
4
Descargas
2
Likes
0
Makes
A tooth-spider!
Remixes two other models (linked).
Because I'm lazy (the hole is literally made by subtracting a leg part from it), they won't fit together well.
**The prints I'm doing are at 50% size for the tooth/body, and 45% size for the legs.**
Print the tooth/head upside-down (I had no success getting it to print the right way up) with support _only from the base_ (you don't need support other than that).
Print the leg on its side (one side is flatter than the other, and that's the side I used). I used support from the base here too, though it probably didn't matter so much.
I used a raft, support-from-base-only, and 0.2mm layers; later prints of the legs used 0.12mm layers
Remixes two other models (linked).
Because I'm lazy (the hole is literally made by subtracting a leg part from it), they won't fit together well.
**The prints I'm doing are at 50% size for the tooth/body, and 45% size for the legs.**
Print the tooth/head upside-down (I had no success getting it to print the right way up) with support _only from the base_ (you don't need support other than that).
Print the leg on its side (one side is flatter than the other, and that's the side I used). I used support from the base here too, though it probably didn't matter so much.
I used a raft, support-from-base-only, and 0.2mm layers; later prints of the legs used 0.12mm layers
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
