Thingiverse
Toothbrush Holder
von jacobn6
6
Downloads
12
Likes
0
Makes
Simple little toothbrush holder I designed for my bathroom after my old one broke. I made it an open concept so it will be easy to clean in the long run.
Materials:
4 Qty. 8mm hex nuts
1 Qty. 8mm x 130mm threaded rod
This was printed in PLA, but any material will work. The bottom is designed to be heavy enough so that even when there is only one brush in the holder, the holder will not tip.
Materials:
4 Qty. 8mm hex nuts
1 Qty. 8mm x 130mm threaded rod
This was printed in PLA, but any material will work. The bottom is designed to be heavy enough so that even when there is only one brush in the holder, the holder will not tip.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!