Thingiverse
Toothless grinder
von epizeuxis
95
Downloads
70
Likes
0
Makes
The model consists of 5 parts
- upper part
- "teeth"
- mesh
- middle part
- bottom part
The Upper and bottom parts come in two variants. One with a small groove for a hairband and the other with a wider groove and holes to hold a 20mm (3/4 inch should fit great) wide strap (I used one made of polypropylene)
Top part + "teeth" and middle + bottom part are connected by threads
REMOVE ALL LOOSE PIECES OF PLASTIC BEFORE USE!
- upper part
- "teeth"
- mesh
- middle part
- bottom part
The Upper and bottom parts come in two variants. One with a small groove for a hairband and the other with a wider groove and holes to hold a 20mm (3/4 inch should fit great) wide strap (I used one made of polypropylene)
Top part + "teeth" and middle + bottom part are connected by threads
REMOVE ALL LOOSE PIECES OF PLASTIC BEFORE USE!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
