Thingiverse
Toothless Herb Grinder
by Travmd24
563
Downloads
566
Likes
1
Makes
All three parts were printed at 0.2mm layer height,15% infill, and 3 perimeters. The middle piece is the only one that needs supports.
This is my first design and has limited use so far, so any feedback will be greatly appreciated. Has a 6.5mm catch under the middle piece.
This is my first design and has limited use so far, so any feedback will be greatly appreciated. Has a 6.5mm catch under the middle piece.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
