Toothpick 0703 Frame

SummaryI couldn't find a frame i liked to transplant my 1s 75x inners too and wanted to try a toothpick style frame. VTX, tucks away in the canopy and the RX goes under the main board there is a cavity to accommodate this. The frame will take upto 65mm props.Battery is held in place with clips on side and elastic band, you can fit an XT30 through the base hole, comes in at 54g with a 1s 600 mah battery.v1.1 updated the scale so it comes in correct, small mod to the mounting pins as they were a bit fragile (increased hole depth to 7mm and added 0.4mm to OD) also added some cable cut outs for the motor wires in base.v1.2 finished the build and the motor wires were about 2mm too short to take under the frame so ran them as in the photo, updated the frame to remove redundant holes. have to say i do like the way it flies/floats. Hope you enjoy.I've added a new canopy modelled and tested (10/07/19) in PLA it has 3 attachment points, will print it later in TPU for added flexibility. I