Toothpick Dispenser

Toothpick Dispenser

This was original designed to make out of some hardwood, but I haven't gotten around to it yet, so I decide to do a quick mock up of it to print. Currently it will hold about 32 (16 per side) toothpicks. Might make it a little taller in the future to hold more.


PRINTING NOTES:

Material: Doesn't mater
Infill: 10
Speed:100 (w/.06 Nozzle)
Adhesion: Skirt
Supports: No


PRINTING POSITIONS:

• Base and Sides, can be printed as shown.
• Divider and (2) Roof halves lay flat.


ASSEMBLLY:

1. Check the fit of the divider into the base to make sure the ends of the divider go all the way to the ends of the slot in the base. I did slightly sand just the bottom part of the corner edges for this to make it easier.

2. Check the fit with the sides installed. Remove the divider and put the side pieces on and reinstall the divider. Work the side pieces up and down until it pushes the bottom parts of divider out and glides smoothly.

3. Remove th